NASA Sends Spacecraft on Mission to Comet Hartley 2
NASA has approved the retargeting of the Epoxi mission for a flyby of comet Hartley 2 on Oct. 11, 2010. Hartley 2 was chosen as Epoxi's destination after the initial target, comet Boethin, could not be found. Scientists theorize comet Boethin may have broken up into pieces too small for detection.
The Epoxi mission melds two compelling science investigations -- the Extrasolar Planet Observation and Characterization and the Deep Impact Extended Investigation. Both investigations will be performed using the Deep Impact spacecraft.
In addition to investigating comet Hartley 2, the spacecraft will point the larger of its two telescopes at nearby previously discovered extrasolar planetary systems in late January 2008. It will study the physical properties of giant planets and search for rings, moons and planets as small as three Earth masses. It also will look at Earth as though it were an extrasolar planet to provide data that could become the standard for characterizing these types of planets.
 |
| This is an artist's rendition of the Deep Impact flyby spacecraft releasing its impactor, 24 hours before the impact event in July 2005. Pictured from left to right are comet Tempel 1, the impactor, and the flyby spacecraft. The impactor is a 370-kilogram mass with an onboard guidance system. The flyby spacecraft includes a solar panel (right), a high-gain antenna (top), a debris shield (left, background), and science instruments for high and medium resolution imaging, infrared spectroscopy, and optical navigation (yellow box and cylinder, lower left). The fly spacecraft is about 3.2 meters long, 1.7 meters wide, and 2.3 meters high. The launch payload has a mass of 1020 kilograms. The flyby spacecraft is being re-christened as EPOXI. Credit: NASA/JPL |
"The search for exosolar planetary systems is one of the most intriguing explorations of our time," said Drake Deming, Epoxi deputy principal investigator at NASA's Goddard Space Flight Center, Greenbelt, Md. "With Epoxi we have the potential to discover new worlds and even analyze the light they emit to perhaps discover what atmospheres they possess."
The mission's closest approach to the small half-mile-wide comet will be about nearly a thousand kilometers (620 miles). The spacecraft will employ the same suite of two science instruments the Deep Impact spacecraft used during its prime mission to guide an impactor into comet Tempel 1 in July 2005.
If Epoxi's observations of Hartley 2 show it is similar to one of the other comets that have been observed, this new class of comets will be defined for the first time. If the comet displays different characteristics, it would deepen the mystery of cometary diversity.
"When comet Boethin could not be located, we went to our backup, which is every bit as interesting but about two years farther down the road," said Tom Duxbury, Epoxi project manager at NASA's Jet Propulsion Laboratory in Pasadena, Calif.
Mission controllers at JPL began directing Epoxi towards Hartley 2 on Nov. 1. They commanded the spacecraft to perform a three-minute rocket burn that changed the spacecraft's velocity. Epoxi's new trajectory sets the stage for three Earth flybys, the first on Dec. 31, 2007. This places the spacecraft into an orbital "holding pattern" until it's time for the optimal encounter of comet Hartley 2 in 2010.
"Hartley 2 is scientifically just as interesting as comet Boethin because both have relatively small, active nuclei," said Michael A'Hearn, principal investigator for Epoxi at the University of Maryland, College Park.
Epoxi's low mission cost of $40 million is achieved by taking advantage of the existing Deep Impact spacecraft.
JPL manages Epoxi for NASA's Science Mission Directorate, Washington. The spacecraft was built for NASA by Ball Aerospace & Technologies Corp., Boulder, Colo.
For information about Epoxi, visit http://www.nasa.gov/epoxi .
|
